Untitled Document

How to connect your VoIP phone through your computer's wireless network

This technique works with any type of wireless networking.

Windows
1. Get connected! Make sure you have internet access. Launch a browser to check.
2. Go to Control Panel --> Network Connections --> select the National
Broadband Access icon, right click on it and select Properties.
3. Click on the Advanced tab.
4. There will be a checkbox that says "Allow other network users to
connect through this computer's Internet connection". Make sure that it is
checked.
5. Click OK
6. Plug the phone into the laptop's Ethernet port and turn it on.
7. Restart the laptop.
8. Make sure that you still have Internet access thru the Broadband Card.
9. Go back to Control Panel --> Network Connections --> select the National
Broadband Access icon, right click on it and select Properties.
10. Click on the Advanced tab.
11. Underneath "Allow other network users to connect through this computer's Internet connection" is a drop down menu. Click on the Down Arrow and select Local Area Connection.
12. Click OK

Macintosh OS X
1. Get connected! Make sure you have internet access. Launch a browser to check.
2. Plug the phone into the laptop's Ethernet port and turn it on.
3. Go to System Preferences.
4. Click on Sharing (under the Internet & Network preferences).
5. Turn on Personal Web Sharing by clicking on the box before it (a check mark will appear in it to verify that it is turned on).
6. Above this checklist, you will see Services, Firewall and Internet. Click on Internet.
7. Across Share your connection from: there is a drop down menu. Select Airport
8. Turn on Built-in Ethernet by clicking on the box before it (a check mark will appear in it to verify that it is turned on).
9. Click on the Start button to turn on Internet Sharing. You may now close this window.
Continue on to the videophone:
10. Press MENU button
11. Using the arrow keys, select Configuration and press MENU to enter selection.
12. Select Network Configuration; press MENU.
13. Select DHCP; press MENU. (Enabled text should be white.)
14. Press on the right or left arrow so that it is Disabled; press MENU.
15. Select IP Address; press MENU.
16. Change the current IP Address: 0.0.0.0 to: 192.168.2.2; press MENU.
17. Select Subnet Mask; press MENU.
18. Change the current Subnet Mask: 0.0.0.0 to: 255.255.255.0; press MENU.
19. Select Gateway; press MENU.
20. Change the current Gateway 0.0.0.0 to: 192.168.2.1; press MENU.
21. Click the left arrow 3 times.
22. You will be asked to Save System Setting and Reboot. Press MENU to select yes.

Where's the uppercase letters when adding to the address book?
The mute/redial button serves as a caps lock when typing in names.

Where's the spacebar key?
The space key is the 1 button. If you look at the #1 button there is a space in between the underscore and @. When inserting a space, cycle through the 1 button and use the right arrow button to move the cursor over.